On-site Data Collection

# Measuring Tree Height using a Clinometer

The following article was authored by Mike Steiner and Jason Baker.

Tree heights are measured using a principle called triangulation and with a device called a clinometer. The clinometers can be purchased from many US suppliers and are easy to use, very practical and can be mastered easily. Probably the most important step in the process of triangulation is correctly measuring the distance from the tree.

Clinometers may be purchased from many vendor sources. There are a variety of clinometers available today so check your instrument to see which side of the scale is for topo and which is for %.

There are a variety of clinometers available today so check your instrument to see which side of
the scale is for topo and which is for %. Figure 3 above illustrates a typical clinometer with the
% scale on the left and the topo scale on the right. Verify the scales by leveling the clinometer
parallel with the height of your eyes until the scale reads “0” and the scale indicators will be
visible.

## Using the Topo Scale (right)

If tree height is greater than 50’, follow the section below on use of the left or the % scale.

1. Height can be measured with this scale at 66 feet from the center of the base of the tree. Measure or pace out from the center of the tree base perpendicular to the slope for the best and easiest readings.
2. Read the right scale directly with both eyes open (Figure 4). The height measurement is in feet.
3. Height is measured from the base of tree at ground level to top of crown, peak of terminal leader (dendritic tree forms) or the average of the tree crown (Figure 5). Read the right scale for measurement of height.
4. Figure 6 and Figure 7 illustrate the effects of slope on tree height measurement.

## Using the Percent Scale (left)

1. Height can be measured with this scale at 100 feet from the center of the base of the tree. Measure or pace out from the center of the tree base perpendicular to the slope for the best and easiest readings.
2. Read the right scale directly with both eyes open (Figure 4). The height measurement is in feet.
3. Height is measured from the base of tree at ground level to top of crown or peak of terminal leader (Figure 5). Read the left scale for measurement of height.
4. Figure 6 and Figure 7 illustrate the effects of slope on tree height measurement.
5. Follow the rules as stated
6. If tree height is greater than 100’, the distance from the base of the tree should be doubled to 200’, read the % scale on the left side of the clinometer and multiply by 2 to get tree height in feet.